Walls & Trim guide
How to measure for baseboard and crown molding
Trim is measured by length. Baseboard follows the floor and stops at door openings; crown molding follows the ceiling and runs straight past them. Either way, convert the net length into the piece size sold at your store.
Walk the room with a tape
Measure each wall and mark doorways, built-ins, cabinets, and openings where trim stops. Add the wall lengths rather than assuming the room is perfectly rectangular. Note every outside corner and return.
Crown: run = perimeter + soffit and bump-out returns
Pieces = round up(length × (1 + allowance) ÷ piece length)
Worked example
A 12 × 10 ft room has a 44 ft perimeter. With 6 ft of door openings, baseboard covers 38 ft. Adding 10% gives 41.8 ft; in 8 ft pieces that is 5.23, so buy 6 pieces. Crown molding for the same room runs the full 44 ft; with 15% for corner cuts that is 50.6 ft, or 5 pieces at 12 ft.
Plan it wall by wall
The percentage method gives a good total, but a cut list shows whether the pieces actually work. For the same 12 × 10 ft room with a 3 ft door in the middle of each 10 ft wall, the runs are 12, 12, 3.5, 3.5, 3.5, and 3.5 ft.
- Each 12 ft wall: one 8 ft piece plus a 4 ft piece.
- The four 3.5 ft runs: two pieces from each 8 ft stick.
- The two 4 ft pieces come from one more 8 ft stick, so the room needs 5 full sticks with almost nothing left over.
That is one fewer than the 6 pieces the percentage method suggests, but it leaves no spare for a miscut. With 12 ft stock, each long wall takes one piece with no joint, and three of the short runs fit on a third piece, so the fourth needs a fourth piece: 4 pieces of 12 ft. Buying the sixth 8 ft piece, or a 12 ft piece, is the safer plan.
Shoe molding and quarter round
If you add shoe molding or quarter round to hide the gap at the floor, it runs the same length as the baseboard. Buy it in the same lengths, with the same allowance.
Allow for joints and cuts
Longer pieces reduce joints but are harder to transport and handle. A modest allowance covers damaged ends and unusable offcuts; add more when the room has many corners or you are matching an existing profile.
Why crown gets more allowance
Crown sits at an angle between wall and ceiling, so each corner takes a compound miter or a cope, and a miscut piece is often too short to reuse. Home improvement retailers commonly suggest ordering 10–15% extra. Decorative corner blocks let you make square cuts instead and reduce waste.
Frequently asked questions
What length of baseboard should I buy?
Baseboard is commonly sold in lengths such as 8, 12, and 16 ft. Longer pieces mean fewer joints on long walls but are harder to carry and fit in a car.
Should I miter or cope inside corners?
Many carpenters cope inside corners, cutting the profile of one piece to fit against the face of the other, because it stays tight if the walls move. Outside corners are mitered.
Do I include closets in the baseboard length?
Yes, if they get the same trim. Measure closet walls and subtract the closet door opening just like any other doorway.
How much extra crown molding should I buy?
Retail installation guides commonly suggest 10 to 15 percent extra for crown. Rooms with many corners, or a first attempt at cutting crown, justify the higher end.